View Single Post
Old 03-01-2023, 03:31 AM   #12
SamanthaP0930
Getting Wild
 
SamanthaP0930's Avatar
Yamaha
 
Join Date: Sep 2020
Location: Clearwater, Florida
Posts: 106
Default Re: Install new Alltrax 48300 and Batteries

Ty! I'm not a good crimper, I have the heat shrink ones. Thank goodness!
I have connected everything to the solenoid. I was just looking at this diode thingy. Scotty said there was a post he did w pictures, I'm going to see if I can find that to try and see where this thing should go. Besides that, I think everything is where it should be. I'll go over it again before I put the batteries in though. The yellow/red and red were already on the tow switch from previous. I need to figure out the switch they installed under the dash, if I remember correctly I think it was taken from where the switch is suppose to be or come to think about it, I think I fed off that switch for the "emergency " shut off.. I'm not sure lol havent made it to the front yet lol
SamanthaP0930 is offline   Reply With Quote