View Single Post
Old 11-19-2022, 04:50 PM   #14
DaveTM
Gone Wild
 
DaveTM's Avatar
 
Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 6,204
Default Re: ElCon charger ZEVA BMS...and a charging "thing"

Quote:
Originally Posted by Pat911 View Post
Sounds like the touch calibration is off, i.e. the screen doesn’t know where you’re actually touching it. Is there a screen or touch calibration setting in the menus anywhere.
No. I’ve never come across that nor is there any instructions to that. I did manage to change a few settings before it went wonky. I set the pack charge to 56v and the “full charge “ setting to 55v.

I know that “leaves some on the table” , but I need to check the charger issue first…as soon as I can figure out how to test the output of a smart charger….the issue that started it all.

For the screen....(see pic below....even though this screen pic doesn't have Icon buttons)....You have to touch it below where the actual icon is. And the "leave settings" button is located at the bottom....thus off the screen and unable to work.

DaveTM is offline   Reply With Quote