Re: 3D printer thread
I think I got it!
CC= Club Car/Color Choice
5PM= 5 Panel mirror
DS= Driver Side
PS= Passenger Side
The 12v washer has an OD of 40mm and works great for over sized cut outs when installing USB power outlets. The name is funky in the pic but its the only washer file. The profile has a slight tapered edge.
Mirror mount holes are 7mm and due to 3D printing characteristics they may need cleaned up with a 1/4inn drill bit. I use 3 outlines when printing to allow safe up sizing of these holes. At 70% fill the parts are plenty strong enough to hold the mirror.
The precedent mounting holes are 4in on center and the mirror mount position is 3in low. Its as close to the factory mount position as I could get it.
Yamaha mounts have not been physically installed yet. The mounting holes are 3-9/16 on center spacing and the same 3inch drop.
I have not printed and installed the CCprecedent color choice mount yet. I'm printing the second to last piece of the first set now. Good chance it will need revised.
|