Buggies Gone Wild Golf Cart Forum - View Single Post

raydhd · 08-09-2015, 05:37 PM

Made a S/G extender bracket today with the plasma cutter. I got an ax 32 belt to move the S/G away from the engine. Still plenty of space in my G14.Worked great even did a plunge cut to make a second hole in the bracket.Then used a HF step bit to clean up the hole.Sure beats drilling a pilot hole on 3/8 steel.Tried 90 psi on pressure. Did not see ant big difference on cuts but looks hard on the chineese input hose.Used #5 darkening lens in flip eye shield.I had used # 5 flip lens over my glasses before but felt some eye burn,suspect rays getting around them.Really a neat toy for $192.Yesterday cut all those tabs off the swing arm that held the belly shield on.A lot easier getting the plasma cutter head in the than any other cutting device.

08-09-2015, 05:37 PM	#12
raydhd VC 460 CLONE GONE WILD Join Date: Oct 2014 Location: Ray BY The Bay NJ Posts: 10,647	Re: cheap plasma cutter Made a S/G extender bracket today with the plasma cutter. I got an ax 32 belt to move the S/G away from the engine. Still plenty of space in my G14.Worked great even did a plunge cut to make a second hole in the bracket.Then used a HF step bit to clean up the hole.Sure beats drilling a pilot hole on 3/8 steel.Tried 90 psi on pressure. Did not see ant big difference on cuts but looks hard on the chineese input hose.Used #5 darkening lens in flip eye shield.I had used # 5 flip lens over my glasses before but felt some eye burn,suspect rays getting around them.Really a neat toy for $192.Yesterday cut all those tabs off the swing arm that held the belly shield on.A lot easier getting the plasma cutter head in the than any other cutting device.