Quote:
Originally Posted by jeffro22
Trying to get the last few pieces needed to make the lithium swap in my 2010 clubcar Limo cart
SO far I have 14 Leaf batteries, Chargery BMS (with temp sensor and shunt) and a 58.1v charger (although might re-visit the charger)
Getting ready to start building battery box, putting pack together and lining old battery tub
Have spent numerous hours reading and re-reading through all the build threads and trying to get a complete list together.
Where can I source some bus bars that span 4 cells? --The ones the came with my kit are only 2 hole (they were made to put together 2 separate 7 cell packs)
Is the mzj-400a Ok to substitute in place of the gigavac contactor?
BMS wires- Where can I get correct connectors for connecting to busbars? or will small ring terminals be OK?
|
I ordered copper stock from mcmaster Carr 1/8in x 3/4in x 36in and made my own.
I actually just had a new gigavac contactor fail on me. The mjz400 will do everything the gigavac will just install a fly back diode across the coil terminals if the chargery BMS doesnt have internal suppression.
Sent from my SM-G960U using Tapatalk