Re: Speed code 4 not working
If you want to make sure the MCOR is working correctly AND your throttle is reaching 100%, do the following:
With the batteries connected, Tow/Run switch in Run; place the black (–) probe on packs main Negative post and the red (+) probe on the yellow wire at the 3-pin connector near the MCOR or at the Controller. (The reading should be approximately ~0.32 - .5vdc with the pedal up). Slowly press the Go Pedal and the readings should increase gradually until it reaches ~4.65 - 5vdc when the pedal is fully depressed. (Anything less than 4.60vdc and you are not reaching full throttle).
And I have had a few SC4's over the years, they have always worked exactly as stated unless I had a weak pack that could not get me there or an MCOR that was not reaching 100% throttle.
|