Re: Mode Lock 3 not working
Changed the setting 400amp 6000 speed limit and still not going over 2300-2500rpm.
speed sensor passes the roll away test. I will check the speed sensor using the method in one of Your (Sergio's) responses in old posts "Bad sensor or something else" when doing this test should I ground to the black wire or to the battery pack?
To test your sensor harness:
Disconnect the 3-pin plug from the speed sensor, with the Tow/Run switch on "Run", You should get 15v between the black and Red wires at the 3-pin connector.
You should also get 5v between black and green wires.
To test the sensor:
If the tests above are correct, You can test the output of the sensor "Green" wire by lifting one wheel and turning it by hand.
With the 3-pin plug connected and a wire piercing probe on the Green wire, the voltage will go from 0 to 5v - 24 times on a full wheel revolution.
|