Quote:
Originally Posted by jetfan1950
Friend recently purchased a Model # E198. Runs OK for a few minutes then drops into DCS mode (2 mph). Stays that way until a recharge or battery disconnect/reconnect. Pack voltage is good at 38V before and after it goes into DCS mode. Looking at the solenoid (White-Rodgers 70-120224) and it's mounted upside down. The small terminal wires seem to be wired correctly (Blue is now on the left and the yellow is on the right). The large terminals however are connected as if the unit was mounted right side up (battery connected to the right side, controller to the left side). Could this be causing the DCS condition?
|
The solenoid is not effected by which side the battery or control cable is on or which side the (+) or (-) activation wires are on. The solenoid may be welding itself closed (sticking)? Or operating voltage may be dropping below acceptable levels.