View Single Post
Old 01-14-2020, 12:16 PM   #5
JohnnieB
Techno-Nerd
 
JohnnieB's Avatar
E-Z-GO
 
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
Default Re: DCS solenoid no click hot resistor

Quote:
Originally Posted by RCR808 View Post
1. Yes I am aware of Pin 2 being out of spec, which I suspected the ITS being bad therefor I replaced ITS and no difference still reading 12volt.

2. I will try a new pedal switch, thank you for the tip.

3. By the way you’re 38.2v or higher on newer fully charged (well)maintained batteries!!
1. There is an in-line connector it the end of the gray cable where it joins the cart's wiring harness. When the connections get corroded, the ITS voltages can get weird. Replacing that in-line connector with individual butt-splices or solder joints and sealing air tight with marine grade (adhesive filled) shrink tubing takes care of that issue.

2.

3. True, but an at-rest voltage of ~37.***V could mean a bad charger or other issue as well as old and poorly maintained batteries.
JohnnieB is offline   Reply With Quote