Buggies Gone Wild Golf Cart Forum - View Single Post

JohnnieB · 03-05-2013, 04:58 AM

Can you post a picture showing the two microswitches and wiring?
According to the schematic, the orange wire should be attached to MS-4 and the black wire should be attached to the beeper.

Apply a small amount of dielectric grease to the F/R switch contacts so it shifts easier and loosen the nut a little if need be.
It is a balancing act, tight enough to insure full contact, loose enough to shift.

03-05-2013, 04:58 AM	#7
JohnnieB Techno-Nerd Join Date: Jun 2011 Location: West Virginia Posts: 19,654	Re: FnR switch high pitch noise Can you post a picture showing the two microswitches and wiring? According to the schematic, the orange wire should be attached to MS-4 and the black wire should be attached to the beeper. Apply a small amount of dielectric grease to the F/R switch contacts so it shifts easier and loosen the nut a little if need be. It is a balancing act, tight enough to insure full contact, loose enough to shift.