Buggies Gone Wild Golf Cart Forum - View Single Post - 0-5v throttle tested

biphase · 07-15-2019, 09:10 AM

A typical EzGo ITS throttle sensor does not produce a 0-5V output. Some Chinese manufacturers use the EzGo ITS in combination with a separate small PC board containing a circuit that converts the native ITS signal to 0-5V to make it compatible with a Type 2 throttle. In later versions that PC board is actually built into the ITS module and is connected to the harness via a 3-pin Molex type connector also built into the ITS module. Can you determine whether you have either of the two type modules described above?

07-15-2019, 09:10 AM	#6
biphase Gone Wild Join Date: Jan 2009 Location: Ocala, FL Posts: 384	Re: 0-5v throttle tested and help needed A typical EzGo ITS throttle sensor does not produce a 0-5V output. Some Chinese manufacturers use the EzGo ITS in combination with a separate small PC board containing a circuit that converts the native ITS signal to 0-5V to make it compatible with a Type 2 throttle. In later versions that PC board is actually built into the ITS module and is connected to the harness via a 3-pin Molex type connector also built into the ITS module. Can you determine whether you have either of the two type modules described above?