Re: 0-5v throttle tested and help needed
I got it to work. Well sort of. I get a throttle fault on the controller when I turn it on. On jack stands it moves the wheels. Full speed in reverse and half speed going forward. If I put it in 4x4 the other solenoid kicks in but then nothing happens. No forward nor reverse action.
I have done the following:
New Batteries
New Throttle pedal 0-5v
Had both controllers repaired
New brake master cylinder
New solenoids
New switches (FNR & 2wd/4wd)
New LED lights
New battery meter
New key switch
I may have something cross wired but I would not think so since it moves the motor.
It would really help if I knew where the wires on the pedal are supposed to go. I know that the red is my power in and the green is my ground. I believe that the yellow goes back to my controller throttle input 0-5v. Blue goes somewhere...any of that right???
Since I am new I cannot post a picture.
Sent from my ONEPLUS A6003 using Tapatalk
|