[jtb74]

Thanks for the replies,


I think you guys convinced me to go the machining route with rpm spring.

Do I need to buy the clutch puller to remove the clutch or is it doable without? if so what tools do I need to take it out.

I'm going to go ahead and order the carb rebuild kit , jet , k&N Filter , High Volume fuel pump. My brother has worked on motorcycle engines in the past and can help me with the carburetor. I figure I might aswell rebuild it since i need to clean it out anyway ( who knows how dirty it is ) . That may turn out to be a poor decision but will have to wait and see.

I ordered the heavy duty rear leaf springs a few minutes ago, that will hopefully help the sagging in the rear.

If anyone has a good source for a 1993 club car manual please let me know , cheapest I've found so far has been 90 bucks , thats tough to do.

Thanks for your help.

james