Re: Club Cart stuck on 3 moh
See what the throttle is sending to the controller. With the batteries connected, Tow/Run switch in Run; place the black (–) probe on packs main Negative post and the red (+) probe on the yellow wire at the 3-pin connector near the MCOR. (The reading should be approximately ~0.32vdc to ~0.5vdc with the pedal up). Slowly press the Go Pedal and the readings should increase until it reaches ~4.65vdc or more when the pedal is fully pressed. (Anything less than 4.60vdc and you are not reaching full throttle). If the reading is erratic or jumps all over the place it is a bad MCOR output signal or you damaged a wire possibly.....
|