View Single Post
Old 05-03-2014, 07:25 AM   #2
JohnnieB
Techno-Nerd
 
JohnnieB's Avatar
E-Z-GO
 
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
Default Re: 01 Ez-go PDS 3/2 Beep code, Solenoid good

If you are getting the full battery pack voltage on J1 Pins 4 & 5 and the solenoid isn't bad, the controller is bad.

There was a typo in the test procedure I posted. Full pack voltage should be on J1 Pin-7 rather than J1 Pin-6. You might get full pack voltage on Pin-6, but it could be lower since the voltage from Pin-7 is going through the solenoid coil.
JohnnieB is offline   Reply With Quote