It's been a while since I have posted. Life gets in the way as usual.
Finally got the motor mounts welded in and the engine has been dropped in place. It's a really tight squeeze, but will work.
Motor mounts are 1-1/4" square tubing welded to the frame with 1/4" flat stock welded to the square tubing for a flat seating area so I could mount the rubber isolators and drop the engine in.
I will have to relocate the radiator as there is just not enough room where I would like it to go. I am thinking I will either have to mount it up front or between the bars of the roll cage. Open to ideas/suggestions.
IMG-0951.jpg
1/4" flat stock with original Kubota rubber isolators mounted.
IMG-0955.jpg
Under view of the 1-1/4" square tubing welded to the frame.
IMG-0958.jpg
Top down view of the engine - tight squeeze for sure!
IMG-0959.jpg
Side view of the engine.
IMG-0960.jpg
Rear view of the engine.