09-25-2015, 01:23 PM
|
#10
|
|
Guest
|
Re: 1995 ez go series won't move
solenoid test
Quote:
Disconnect the negative battery cable from the battery. remove all wires, restorer , and diode from solenoid
test 1
Connect an volt meter, set on continuity, place on the two large terminal studs. The meter should indicate no continuity, Replace the solenoid if continuity is present.
test 2
Using jumper wires attach from main positive and main negative of battery pack to the two small solenoid studs, polarity is not important. You should hear a click as the solenoid engages, and the meter should indicate continuity on the two large terminals. Replace the solenoid if continuity is not present.
if solenoid clicks rapidly solenoid is bad
|
[/quote] |
|
|
|
|
|