Quote:
Originally Posted by ThreeCW
wanted to share it on it's own thread as it may be helpful for others looking to pull a similarly configured wheel hub.
:
|
I posted this recently in a Cushman Hawk Brake thread (
https://www.buggiesgonewild.com/showthread.php?t=119829) but also wanted to share it on it's own thread as it may be helpful for others looking to pull a similarly configured wheel hub.
I made up a puller for my rear wheel hubs on my 1998 Cushman Hawk using a piece of 1/2" steel plate I had kicking around. The 1/2" plate is overkill, but it is what I had ... 1/4" or 3/8" should work just as well.
The series of pictures should be self explanatory ... of course I removed the wheel hub retaining nut prior to pulling the hub ... although the pictures does not show that.
To pull the last part of the hub, I positioned a small 1" long bolt over the axle stub and then used the wheel hub pulling plate to finish the pull.
No hammering required