Buggies Gone Wild Golf Cart Forum - View Single Post - Precedent AllSports Lift Install Complete, Alignment tips?

ClubCar86 · 12-01-2019, 07:43 PM

I finished my weekend project. Put a 4" Allsports lift kit on our '16 Prececent. with 20.5" tires, I think it may have been a bit much. I was on the fence between the 3" and 4" and it turned out higher than I expected. Oh well maybe it will settle down? All was good until I got to the rear. My two complaints were that the spring U-Bolts were 2" too long (which made for a lot of wrenching), and I was really scratching my head at the way Allsports sandwiches the factory brake cable plate between the axle and their flat plate. The factory cable plate has a lip on it, so it doesn't sit nice in the "sandwich." I ended up stacking washers on either side of the factory cable plate to make it work. Is this normal -Seems like a very poor oversight to an otherwise nice kit? They included 8 washers in the kit, but there was no mention where to use them.

Also, any tips for adjusting the camber and toe on this kit? There was nothing in the instructions on that either. The joints at the top/bottom of the A Arms were installed all the way in (From the factory). I guess I will be taking the wheel off and un-screwing them a little so I can get some adjustment there.

12-01-2019, 07:43 PM	#1
ClubCar86 Gone Wild Join Date: Dec 2016 Location: Melbourne, FL Posts: 180	Precedent AllSports Lift Install Complete, Alignment tips? I finished my weekend project. Put a 4" Allsports lift kit on our '16 Prececent. with 20.5" tires, I think it may have been a bit much. I was on the fence between the 3" and 4" and it turned out higher than I expected. Oh well maybe it will settle down? All was good until I got to the rear. My two complaints were that the spring U-Bolts were 2" too long (which made for a lot of wrenching), and I was really scratching my head at the way Allsports sandwiches the factory brake cable plate between the axle and their flat plate. The factory cable plate has a lip on it, so it doesn't sit nice in the "sandwich." I ended up stacking washers on either side of the factory cable plate to make it work. Is this normal -Seems like a very poor oversight to an otherwise nice kit? They included 8 washers in the kit, but there was no mention where to use them. Also, any tips for adjusting the camber and toe on this kit? There was nothing in the instructions on that either. The joints at the top/bottom of the A Arms were installed all the way in (From the factory). I guess I will be taking the wheel off and un-screwing them a little so I can get some adjustment there.