Re: Navitas 1000 controller
I would say the first step is finding out what the blink code means... Most controls will have a list of faults with information to troubleshoot them. Depending on the severity of the fault one of the troubleshooting options may be 'replace controller' So if you try everything else it says to do first that leaves you with a probable rebuild situation.
I don't know much about Nivitas and BBB, but this small amount of info I have that has both companies logos on it (not sure if its correct but its possibly the system you are dealing with) says solid red with 3 green flashes is a
Pedal Fault. "The pedal ahs 2 independent sensors that are not consistent.
Check Pedal wiring - the output voltages from the pedals should sum to 5.0V.
Based on that I would guess the system has a dual-redundant throttle with two outputs. One should read a range of 5-0 while the other goes from 0-5 (half pedal would be 2.5 on each).
|