Buggies Gone Wild Golf Cart Forum - View Single Post

duffer · 02-27-2008, 11:19 PM

Rotten
The switch needs no mounting brackets. Just drill the 9/16 hole in the center upper portion of the brake pedal. Remove the jam nut from the plunger and stick the plunger thru the hole from front to rear. Install the jam nut and tighten. Run your wires from the electric source under the floor and up the brake pedal using zip ties. Attach wires to the 2 terminals. When your foot depresses the plunger, the switch completes the circuit and the brake lights come on. It doesn't look pretty but is functional!!!!

02-27-2008, 11:19 PM	#10
duffer Not Yet Wild Join Date: Jan 2008 Location: The Villages, Fl Posts: 20	Re: Brake light switch Rotten The switch needs no mounting brackets. Just drill the 9/16 hole in the center upper portion of the brake pedal. Remove the jam nut from the plunger and stick the plunger thru the hole from front to rear. Install the jam nut and tighten. Run your wires from the electric source under the floor and up the brake pedal using zip ties. Attach wires to the 2 terminals. When your foot depresses the plunger, the switch completes the circuit and the brake lights come on. It doesn't look pretty but is functional!!!!