Buggies Gone Wild Golf Cart Forum - View Single Post

mgray70 · 10-01-2018, 07:56 AM

This cart got flooded a little and the controller was obviously toast when the owner brought it to me. I tested the motor both continuity and with power. Motor ran fine. Installed a new XCT. Cart ran great. Then all of a sudden I'm getting a one green one red code which says open, or short circuit. I removed the motor, cleaned and inspected ( I suspected corrosion or stuck brushes) all looked good. Continuity between A1 and A2, continuity between F1 and F2, open from A to F and open to the casing. Reinstalled the motor, and get the same code. What am I overlooking? I hate to buy a motor if it's good. I'm gonna retest it with power later and see if it runs.
Thanks!

Sent from my SM-G930R4 using Tapatalk

10-01-2018, 07:56 AM	#1
mgray70 Gone Wild Join Date: Apr 2013 Location: Deep Run, NC Posts: 2,544	DS IQ new Alltrax fault code. This cart got flooded a little and the controller was obviously toast when the owner brought it to me. I tested the motor both continuity and with power. Motor ran fine. Installed a new XCT. Cart ran great. Then all of a sudden I'm getting a one green one red code which says open, or short circuit. I removed the motor, cleaned and inspected ( I suspected corrosion or stuck brushes) all looked good. Continuity between A1 and A2, continuity between F1 and F2, open from A to F and open to the casing. Reinstalled the motor, and get the same code. What am I overlooking? I hate to buy a motor if it's good. I'm gonna retest it with power later and see if it runs. Thanks! Sent from my SM-G930R4 using Tapatalk