Quote:
Originally Posted by JohnnieB
You didn't identify the drive type, but said both F and R microswitches tested good, so I suspect it is a sepex drive (DCS in a 1999) rather than a series drive.
If it is a DCS and runs in one direction but not the other, either the controller is bad, or the F/R voltage isn't getting to the controller.
On the other hand, if it is a series drive and only going in one direction, chances are high that it is a F/R switch issue.
|
It is the indeed the DCS model. I'm suspecting the controller at this point. The relay is engaging & I can hear a slight pulsation somewhere, but I can't pin point it & the cart does not move. However as I mentioned before I do get a voltage drop on my dash gauge.
What would I do to test the controller is in fact getting the voltage it needs to power forward? And what terminals at the motor should have voltage? I'm trying to figure out what's the power in/power out of the controller when in forward.
Thanks