Finally getting around to adding onboard USB charging.
I wanted it to be easily removable and replaceable to accommodate future changes to cables and or possible failure of this aftermarket component.
Bought
this charger with input voltage display that switches to display output wattage when something is plugged in.
Did not want to run any new power wires so I'm
tapping the fuse block with this. My Moke uses ATM mini fuses.
The charger already has an inline F10AL250V fast-blow 10 amp 250 volt glass fuse. I'm still going to use that + the ATM mini fuse in the block.
Because I only had 15 amp mini fuses, I'm rough-fitting this with a 15 amp mini to test it. The final install will use a 10 amp mini to match the glass fuse.
PXL_20230204_193053623.jpg