Thread: Fuel Pumps
View Single Post
Old 06-27-2022, 10:35 AM   #9
Lochlin
Gone Wild
 
Join Date: May 2011
Location: Pittsburgh
Posts: 2,941
Default Re: Fuel Pumps

Your coil should have three wires going into it. A wire that came from the microswitch to coil +, a wire that came from the ignition module to coil +, another wire from the ignition module that goes to coil -. If that microswitch isn't good and depressed there can be no power at the coil. I will have to re-read that sticky.

Assuming your microswitch is good and with the accelerator depressed, you should see 12v on the + terminal of you are holding the red lead of a voltage meter on it while holding the black lead on the voltage meter to ground.

Note that this test will not indicate if your coil or module are good or not. It will only measure if your coil is getting 12v.
Lochlin is offline   Reply With Quote