View Single Post
Old 04-19-2019, 06:34 PM   #4
Conradconrad
Gone Wild
E-Z-GO
 
Join Date: Feb 2017
Location: south florida
Posts: 304
Default Re: Super duty solenoid and XCT 500 wiring

Quote:
Originally Posted by scottyb View Post
Hi Conrad
Can you differentiate between wires and cables in your description? It makes it easier to understand (for me anyway)
Yes, were you able to see the picture I posted? All wires referenced are the 2 gauge wires. I am solely referencing large gauge wires and how the positive of the battery pack, solenoid to controller and controller to motor A2 should be connected. I am not asking about the solenoid activation circuit.

Just to try to rephrase one more time as seen in my picture, can I put a 2 gauge wire that then goes to the B+ controller terminal AND second 2 gauge wire that goes to A2 of the motor on the same solenoid stud.

Or should the solenoid stud only have one 2 gauge wire going to B+ controller terminal and then have another wire at the B+ terminal going to the A2 of the motor. Therefore should I have the two mentioned wires at the solenoid stud or two at the B+ controller terminal.

I think if you read what I just wrote along with looking at my shotty diagram it should make sense

Thanks
Conradconrad is offline   Reply With Quote