Super duty solenoid and XCT 500 wiring
Putting back together my XCT 500 and super duty solenoid and noticed on the wiring diagram from Alltrax and have a question-
On the diagram for PDS- one wire from battery pack to a solenoid stud, the other solenoid stud has one wire going to B+ and then a third wire from B+ to the A2 of the motor. Therefore two wires are connected to the B+ terminal of the Alltrax. Is that the most correct way?
I think previously I had the second solenoid stud having two wires on it - one going to B+ on controller and the other to A2 motor. So my question is does it matter if the two wires are on solenoid stud vs the B+ terminal on controller?
I attached a hand drawn picture. Option 1 is the drawing from Alltrax and option 2 is my question if it could or should not be wired that way
Thanks
|