View Single Post
Old 07-14-2019, 08:26 PM   #4
Bubsbuggie
Gone Wild
 
Join Date: Jun 2019
Posts: 230
Default Re: 23 HP Engine placement concens

Do you think a guy can take out the oil drain plug, put in a 90 degree elbow and then put in a plug into the elbow? Seems like that would be the way to go.

I Think I got a plan on how to raise the rear. Going to get some 4" C-channel, cut the one side down shorter than the other side so that it is slanted and weld a flat piece on top to make it Square stock with an angle on the top. Build a mounting plate and bolt it to the top of the new square stock.
Bubsbuggie is offline   Reply With Quote