Thanks for the response - I'm trying!
However, the wiring diagram in the manual seems different. First, it doesn't really label which wires are from the OEM/Molex plug. I see the Black and White wires coming from the ITS throttle, and that's consistent with the description in the lower-left corner of the page.
I also see a Red wire coming from the foot switch, which seems like a likely candidate for coming through the OEM plug, but the diagram shows it going to the + solenoid terminal, not to the Red in J1.
Then, the wire that IS shown as going to the Red in J1 comes from the + solenoid terminal. That doesn't seem likely to be the Red in the OEM plug.
So, in the wiring diagram, where does the Red wire in the OEM plug come from? And is it supposed to travel through the + solenoid terminal? What am I missing?
Thanks.
Bob
Quote:
Originally Posted by scottyb
The white and black are throttle wires J4 and 5 respectively
The red goes to J1 red
The orange goes to J1 blue. This is reduced reverse speed, not needed to run...
See your manual  |