Quote:
Originally Posted by rdkogler
I have uploaded 5 pictures.
Scotty suggest that I reconnect the green as was original.
I am still confused as to
1. the orange wire I don't have
2. hooking up the FN1 to the KSI red on controller with double tap and green. This does not match the schematic provided but I think its correct.
3. must be getting the minus (-) from the black spade terminal to the solenoid and not the B- as the original AXE did.
Drop box link to more pictures
https://www.dropbox.com/sh/6jhzz9i6t...RVJFkjcpa?dl=0
|
1. There orange wire should connect MS-4 to the Blue push-on connector on the SR. (MS-2 is the microswitch on the F/R assembly with the blue wire to the keyswitch on it. The other microswitch is MS-4, which shoul have two wire out, one for the reverse beeper and the other for 1/2 speed reverse on the controller)
2. The FN1 should pick up pack voltage between the keyswitch and pedal switch. You've got is after the pedal switch.
3. Yes.
--------
Looks like you've cut off the in-line connector at the end of the gray cable from the pedal box, so the blue and green wires in picture 3 of 5 attached to your post should be connected. That would connect the keyswitch output to the pedal switch input like is should be. This is also where the FN1 ought to be connected.