Quote:
Originally Posted by flareside_thunder
I'm planning to do this swap this weekend. Was it fairly easy Lilrascals?
Scotty, I bought Handiman's setup. I understand it was set for 48v, is there anything I need to do to be able to run it on my Medalist? Is there a walk through for programming somewhere in the interwebs?
|
It was easy for me because I just rewired mine front to back and upgraded it to 2 awg wires. It will be a super tight fit onto the heat sink with not alot of room side to side. And I had to drill and tap a hole for the lower hold down. Just upgrading the wires to 2awg made a difference with the new controller I was able to climb a huge hill with about a total of about 650 lbs on the cart and batteries only at about 37.3 volts
Sent from my SM-G935V using Tapatalk