[jpmcdo]

Thanks, I did tear the carb down and cleaned the varnish out but know there is still some there. For examole the needle in the bowl is two parts. I couldn't get those apart wihou damaging them. I blew all the needles out, put everything together andthe cart works, but is sluggish. By the way, before you pull the needle out tighten it gently and count the turns 2.5 is close to right. Then take it out. That's the easiest way to figure out the setting but somone else here may know a better way.

Unthinking that if I rebuild the carb, I'm getting fresh parts that dont have 25 years of wear.