Re: 1990 Club car With flat head Rev limiter question and govenor question
When Gov Arm is at rest it should be parallel with the rear axel.
"Gov Rod" Straight end goes in Gov Arm, 90 deg bend end goes in Throttle Plate Pivot Lever.
Should be a plastic bushing in Throttle Plate and spring clip to hold rod in Throttle Plate
Loosen Rod bolt at Gov Arm
Push Throttle wide open and hold there.
Pull Gov Arm towards the Carb till it stops and hold there "It dosen't move very far"
Tighten bolt at Gov Arm.
Good Luck
|