Re: Need pics, front body with Z type lift.
I made a plate out of steel that was the 9"s that covered the front bumper the from the top of the old bumper mounting plate I tapered the new ate outwards to the inside measurement of the cowl. Then back. My nose plate bolts to the original bumper hole and to the top of the shock support tubing. Then I defamed the brush guard to mount to the top if the new face plate. if you pic the plate in your head then find center. On the bottom it's like 9 1/2 inches wide and up 3 1/2 (I think) then that point tapers out to the inner width of the cowling mounting Wich I think was like 12 3/4 wide then a break in the plate to go to the shock tubing. I'll try to post a few pic of mom tomorrow. (cant do it from my phone)
|