Re: 95 ds clicks but won't move?
This cart does not have a MCOR as stated above it has a true 0-5k potentiometer.
The solenoid clicks - so the micro switches mentioned are working.
The problem lies in the pot signal or control power supply or high amp cables... assuming the motor works? (have you seen it work? )
Here is where you need to start...
Jack one rear wheel off the floor.
You should have 50v (+) to pin #1 on the control when the solenoid clicks
Remove the Pot signal wires (pins 2 & 3) and plug your meter into them. Switch to ohms and check the signal. It should read 0-5k
If both of these tests give good results. Try the motor test with 24v and see the wheel spin. Your is a series motor
|