View Single Post
Old 01-15-2023, 03:20 PM   #11
Myyke
Not Yet Wild
Harley Davidson
 
Join Date: Oct 2022
Location: Athabasca, AB
Posts: 24
Default Re: Primary drive sleeve

Here is a pic of what i had gotten made up for a primary drive sleeve.
1.367”ID bearing OD is 1.368. Press fit bearing into sleeve.
1.48” seal face ID. 1.5” OD on the seal i used.
1.56” OD diameter of the primary sleeve. Used floating flange OD of 1.58”
1.00” wide. 1.03” Inner primary sleeve length.


Checked sleeve for fit in primary clutch first & clutch will slide easy over primary sleeve when motor revs up.
Attached Images
File Type: jpg 296104F4-33FA-44C0-AE68-689544D58802.jpg (111.0 KB, 0 views)
File Type: jpg 6B915827-09F8-4628-9E74-D9E037DCA930.jpg (94.7 KB, 0 views)
Myyke is offline   Reply With Quote