View Single Post
Old 06-12-2022, 01:16 PM   #9
rustynova1
Not Yet Wild
 
Join Date: Jul 2020
Posts: 6
Default Re: Kubota z482 95 club car ds

I actually cut the original motor mount. I removed just before the taper and made it square. I used 2 heim joints for linkage from the mount to frame of cart. The engine I used is mounted by the oil pan. It is thick cast aluminum. I used 2 pieces of square tubing and sat the motor on those, they are welded to the original motor saddle. I had to make the front of the saddle square to get the motor far enough ahead for valve cover to not hit on frame at rear of seat.
rustynova1 is offline   Reply With Quote