View Single Post
Old 01-11-2009, 09:25 PM   #7
scottyb
Happy Carting
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 73,356
Default Re: Resistor to Solid State 36V conversion ?

There are 2 types of throttle indicators out there. Their signal is in ohms resistance. CC stock controller carts use a 5k-0 signal (thats the throttle signal). Everybody else uses 0-5k.... You are going to start from scratch...so you should (IMO) go with the more common 0-5K controller and you will want a Curtis made PB-6 ( Potentiometer = common throttle body used for electric vehicles and that's the ezgo part you mentioned) These two things must be matched..They both need to be 0-5k....You need a good hd 48v solenoid. 700 amps is an awful lot of controller. Who said you needed that much controller for that motor?
scottyb is offline   Reply With Quote