Quote:
Originally Posted by KRAZYMATT
Put mikuni vm32 carb on my vrx460 and installed in club car carryall and used factory club car fuel pump. It appears pressure is too much for the needle to stop the flow of fuel because whenever it’s running there is a constant stream of fuel dumping out of the overflow fitting. I know a lot of people that have issues similar to this install a return line before the carb back to the tank. My question is can I just run that overflow back to tank or should I put in return before the carb? Does anyone use pressure regulator? Any input on things to check or try ? I have not opened it up. I should have time to mess with it Friday and will see where the float level is set also. May need tweaking. Didn’t know if the club car fuel pump (low pressure) would still be too much for the vm carb as I think most applications for this carb are gravity fed tanks...
|
Pictures we need pictures