Re: EZGO PDS - New ALLTRAX XCT48500 and 400a solenoid install. no light - newbie
ScottyB
The red wire goes down to the harness. The middle picture is the wire. Looking at the wiring diagram the red wire then goes to C1 - 5. C1 - 5 has 36v + on it. I assume c1 - 5 gets power through the red wire from the + side of the solenoid.
The run/tow seems to work when i flip the r/t up pin c1 - 4 has 36v. When I flip the r/t down c1-4 has 0v. I did find 36v+ on c1-9. I may have missed that in my previous measurements.
So with the r/t switch up i have 36v on pins 4,5,9,10. With the r/t down I get 5,9,10 with 36v.
Do you or JohnnieB have a list of what voltage each pin should read?
Thanks,
Shawn
|