Re: Alltrax XCT Programming
I would set NORMAL at 50% of the current RPMs and then user 1 at 2/3rds or so and then leave user 2 at 6000 = 'my mode'
Pay attention to the throttle ramp rates in the pdf . And ramp up the reverse to 30, then 40, and 50% with each mode
Personally I set ;
normal to TURF mode & TURBO OFF
user 1 to TURF & TURBO ON
user 2 to STREET & TURBO ON
This will give you a good starting point.
With a bigger controller you can also ramp up amperage with each user but with the XCT300 ? I'd go maybe 250 on normal and 300 (350 peak) on the rest.
|