Thread: run tow switch
View Single Post
Old 05-26-2018, 09:37 PM   #3
BeltedOne
Not Yet Wild
 
Join Date: May 2018
Posts: 3
Default re: run tow switch

I found a wiring diagram on the Kinetek Controls web site. Like the one for the AllTrax, it indicates that the "Run" side wires are spliced together and connected to the diode. However, on the "Tow" side, one wire is connected to the "J3-2" terminal on the controller, and the other is split to connect to both the "J3-1" and "J3-4" terminals on the controller (SXDC GC). The J3 connector is a 4-pin, 2x2 connection.
BeltedOne is offline   Reply With Quote