re: run tow switch
I have a 2007 Fairplay with Kinetek controller. Three of my four wires are tagged as follows: the "Tow" side of the switch has wire tagged "31" on top and "32"on bottom; the "Run" side of the switch has wire tagged "0" on top and the bottom wire is not tagged. All my wires are black.
I found a supposedly 2007 Fairplay wiring schematic on this site, but it depicts an AllTrax controller. I'm not sure that makes a difference. It shows both terminals on the "Run" side of the switch should be spliced together and run to the 10A diode, adjacent to the "Logic Fuse" (10A, >60VDC). One terminal of the "Tow" side of the switch is depicted with an Orange wire connected to the #10 (B+ Power) terminal on the controller, while the other terminal is depicted with a Brown wire splitting to connect to both the Logic Power side of the key switch and the #9 (Logic B+) terminal of the controller.
I am still looking for a wiring diagram that depicts the Kinetek controller.
|