Re: 1998 ez-go txt gas
Make sure your throttle is opening up wide open on carburetor. Look good at it with a flashlight if you have to.
There is no ignition timing to set unless you tweaked the crankshaft key a little but not something we normally do.
You could check the valve timing but you will have to remove the drive clutch off engine to do this. Still sort of hard while the engine is in the cart. Best on workbench.
Wait on the compression tester and post your reading. Disable ignition by removing the front small wire on coil. Hold throttle wide open when testing the compression. Very important because you will get low reading if not.
|