View Single Post
Old 04-15-2019, 05:32 PM   #8
lvandyke
Not Yet Wild
E-Z-GO
 
Join Date: Nov 2018
Location: Azle, TX
Posts: 47
Default Re: electrical problems installing digital volt guage

update to electrical problems w/ DVM installation:
I have 36.2 at pack voltage, reed switch seems intact w/ full voltage readings, pulled cover off stock controller and all looks extremely good. traced key switch pins at J1#8, 9, look intact but of course no voltage reading. controller was in Maintenance mode- so would key switch get power? switch to run mode and recheck? I am cautious on doing much in run mode.

My question is how can I trace the 2 wires for key switch to find where it gets power from? Diagram on J1 looks like it gets power from reed switch at J1 connector pin #4
I'm using wiring diagram pg F-9 fig 9 from EZ GO repair and service manual.
thank for any suggestions. chasing sparks is not my forte
lvandyke is offline   Reply With Quote