Quote:
Originally Posted by Mancebo
So, I completed the swap. Hooked up battery and turned key, controller lit up. All was good. Tested movement forward and reverse, all great. Went to zip tie and button up install and sure enough, tried again and nada. Controller doesn't light up or give error codes.
Where should I start? I checked key switch and battery fuse and fnr switch. All looks good.
|
Since you were zip tying the cables, I suspect a plug got pulled a little. Make sure all plugs are fully seated.
If that doesn't do the trick, disconnect charger and computer, if they are connected, and break out the DVM.
To get an XCT48400-PDS to power up, you need battery pack voltage on J1 Pins 4, 5 and 8. (Unlike the stock PDS controller, you don't have to have a direction selected to power up an XCT)