View Single Post
Old 11-07-2008, 09:53 AM   #4
gornoman
Stay thirsty my friends!
 
gornoman's Avatar
Mixed Breed
 
Join Date: Jan 2007
Location: Suburban Chicago
Posts: 24,283
Default Re: EZ GO Fuse Block for accessory lights 36v? or 12v?

The '98 is a DCS cart, the '97 is a Series/Fleet cart. DCS stands for Drive Control System and was E-Z-Go's first attempt at regenerative braking to control runaway carts. It uses a sepex motor and controller system, and F/R is controlled electrically inside the controller. The Series/Fleet carts use a series motor and controller system and will free-wheel on downslopes. The F/R is handled by a large mechanical switch that reverses polarity and carries the full current from the pack. This is often a weak point in a Fleet cart.
A 12v accessory can be wired across 2-6v batteries in series to achieve 12v. This would eliminate the need for a 36v-12v convertor. These 2 batteries will wear down faster if used in this manner.
gornoman is offline   Reply With Quote