MCOR Bad?
After installing the alltrax 400 and new motor, I have been monitoring and adjusting the combo but I've noticed that the throttle position reading jumps around a lot. There's no way i am fluctuating the petal that much. Thoughts?
I believe this is causing the hard and jumpy acceleration from 0-4mph. 2016 CC Precedent |
Re: MCOR Bad?
You are most likely correct. Not uncommon at all.
|
Re: MCOR Bad?
Here is a quick video of the nonsense... I assume an MCOR4 is the replacement?
https://www.youtube.com/watch?v=HRCmUVFoaOE |
Re: MCOR Bad?
Look on the monitor screen and see if you see the throttle input fluctuating.
|
Re: MCOR Bad?
Quote:
|
Re: MCOR Bad?
|
Re: MCOR Bad?
Have you adjusted the throttle in the Alltrax toolkit?
|
All times are GMT -5. The time now is 05:41 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.