01 Workhorse throttle linkage
I've just put my motor back in after a total re-build, it runs great,but at slow speed it wants to start/stop the engine. I would like to adjust it out so I can poke around the yard without the engine shutting off and on.Do you do this at the rear end or with the linkages going to the carb?I noticed the linkages have threaded ends on them and probably got twisted some during the build.Thanks
|
Re: 01 Workhorse throttle linkage
you can adjust both. i would start with teh rear b/c if you go too much you will loose all low end pedal. I have been known to adj teh throttl linkage a pretty good bit to get better torque, just dont go too much or the carb wont close and you can/will flood the eng
|
Re: 01 Workhorse throttle linkage
Thanks I think I have it like I want it now. I have my lowspeed and it's running good. The carb wasn't closing and I thought it was running rich, but it was the linkage adjustment at the rearend.
|
All times are GMT -5. The time now is 12:19 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.