Curtis 1204-402 Controller Conversion Problems
Hey guys, my 36V v-glide resistor cart kept melting v-glides (yes, I have kids), so I decided to make the jump to a controller. I bought a Curtis 1204-402 off ebay along with a new solenoid and 0-5k pot. Started the install and noticed the A1 terminal on the motor was stripped out, the A2 was in bad shape as well. I took the motor apart and replaced both the A1 & A2 studs. Put everything back together with new cables and the cart would barely move on level ground and wouldnt even begin to climb a hill. I thought it was the controller, so I sent it out to ARS and they rebuilt it. I reinstalled it, but still the same problem. If I measure the voltage across the B+ and M terminals, it only shows 3.5 V with the throttle fully applied. If I jack the rear wheels off the ground and repeat the test, the motor will spin up and the voltage measures 30 V or higher. Any ideas?
|
Re: Curtis 1204-402 Controller Conversion Problems
Sounds like the motor was the culprit melting the v glide drawing too many amps.Now you replaced acouple studs could have damaged the motor.if the b+ had good voltage on a load the M has low voltage and the controller was rebuilt makes me think the motor is drawing too amps.i would try to get a amp draw off the m wire eith a clamp on amp meter see whats it drawing.i have a used motor and rear end for the cart sell it cheap
|
Re: Curtis 1204-402 Controller Conversion Problems
Thanks for the reply Roxyflash, I'll try and get an amp reading and post the results. I may be interested in your motor, how much are you asking for it?
|
Re: Curtis 1204-402 Controller Conversion Problems
100
|
Re: Curtis 1204-402 Controller Conversion Problems
It could also be your batteries. Put your meter on the battery pack and see how much the voltage drops when you apply the throttle. With wheels on the ground.
|
Re: Curtis 1204-402 Controller Conversion Problems
How much to ship to 35951?
|
Re: Curtis 1204-402 Controller Conversion Problems
35 for shipping
|
Re: Curtis 1204-402 Controller Conversion Problems
PM sent
|
Re: Curtis 1204-402 Controller Conversion Problems
Sent you a reply
|
All times are GMT -5. The time now is 11:28 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.